2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


INSPECT FRONT WIPER MOTOR (for LHD)

  1. E144461E61
    Check the LO operation.
    Text in Illustration  
    *a
    Component without harness connected
    (Front Wiper Motor)

    1. Connect the positive battery (+) lead to terminal 1 (+1) of the connector and the negative battery (-) lead to terminal 5 (E), then check that the motor operates at low speed (LO).

      OK:
      Motor operates at low speed (LO).

      If the result is not as specified, replace the front wiper motor.

  1. Check the HI operation.

    1. Connect the positive battery (+) lead to terminal 4 (+2) of the connector and the negative battery (-) lead to terminal 5 (E), then check that the motor operates at high speed (HI).

      OK:
      Motor operates at high speed (HI).

      If the result is not as specified, replace the front wiper motor.

  1. Check the automatic stop operation.

    1. Connect the positive battery (+) lead to terminal 1 (+1) of the connector and the negative battery (-) lead to terminal 5 (E). With the motor operating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

    2. Using SST, connect terminals 3 (S) and 1 (+1). Connect the positive battery (+) lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

      SST
      09843-18040  

    3. E127870E02
      Check that the motor stops automatically in the automatic stop position.
      Text in Illustration  
      *a
      Automatic Stop Position

      OK:
      Refer to the illustration.

      If the result is not as specified, replace the front wiper motor.


INSPECT FRONT WIPER MOTOR (for RHD)

  1. E144461E62
    Check the LO operation.
    Text in Illustration  
    *a
    Component without harness connected
    (Front Wiper Motor)

    1. Connect the positive battery (+) lead to terminal 5 (+1) of the connector and the negative battery (-) lead to terminal 4 (E), then check that the motor operates at low speed (LO).

      OK:
      Motor operates at low speed (LO).

      If the result is not as specified, replace the motor.

  1. Check the HI operation.

    1. Connect the positive battery (+) lead to terminal 3 (+2) of the connector and the negative battery (-) lead to terminal 4 (E), then check that the motor operates at high speed (HI).

      OK:
      Motor operates at high speed (HI).

      If the result is not as specified, replace the motor.

  1. Check the automatic stop operation.

    1. Connect the positive battery (+) lead to terminal 5 (+1) of the connector and the negative battery (-) lead to terminal 4 (E). With the motor operating at low speed (LO), disconnect terminal 5 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

    2. Using SST, connect terminals 1 (S) and 1 (+1). Connect the positive battery (+) lead to terminal 5 (B) of the connector to restart the motor operation at low speed (LO).

      SST
      09843-18040  

    3. E218424E01
      Check that the motor stops automatically in the automatic stop position.
      Text in Illustration  
      *a
      Automatic Stop Position

      OK:
      Refer to the illustration.

      If the result is not as specified, replace the front wiper motor.

← INSPECTION (Jul 2007 – Oct 2010)INSTALLATION (Jul 2007 – Jul 2011) →