2011-2016 FJ Cruiser · Service Manual CRUISE CONTROL SYSTEM

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


1. INSTALL CRUISE CONTROL MAIN SWITCH

  1. E129554
    Install the cruise control main switch with the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Connect the connector.


2. INSTALL STEERING PAD

  1. C128255E01
    Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the circumferencial groove of the "Torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

  1. Using "Torx" socket wrench (T30), tighten the 2 "Torx" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

    NOTICE:
    Tighten the 2 bolts while holding the steering pad to prevent it from moving upward.


3. INSTALL NO. 3 LOWER STEERING WHEEL COVER

  1. C128195
    Install steering wheel cover lower No.3.


4. INSTALL NO. 2 LOWER STEERING WHEEL COVER

  1. C128196
    Install steering wheel cover lower No.2.


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }


6. INSPECT SRS WARNING LIGHT
(Click here)
← INSPECTION (from Jul 2007)INSTALLATION (Nov 2010 – Jul 2012) →