2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Only Passenger Door LOCK / UNLOCK Functions do not Operate

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

The main body ECU receives lock/unlock switch signals and activates the door lock motor accordingly.

WIRING DIAGRAM

B105490E28

INSPECTION PROCEDURE


1. INSPECT FRONT DOOR LOCK ASSEMBLY RH

  1. B118058E01
    Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative(-) → Terminal 1
    Locks
    Battery positive (+) → Terminal 1
    Battery negative(-) → Terminal 4
    Unlocks

  1. Measure the resistance of the unlock detection switch.

    Standard resistance:
    Tester Connection
    Door Lock Condition
    Specified Condition
    7 - 8
    Locked
    10 kΩ or higher
    7 - 8
    Unlocked
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - FRONT DOOR LOCK ASSEMBLY RH)
B140119E02
  1. Disconnect the 1L and E6 main body ECU connectors.

  1. Disconnect the G7 front door lock assembly RH connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    1L-6 (ACT+) - G7-4
    Below 1 Ω
    1L-18 (ACT-) - G7-1
    Below 1 Ω
    E6-30 (LSWP) - G7-7
    Below 1 Ω
    G7-8 - Body ground
    Below 1 Ω
    1L-6 (ACT+) or G7-4 - Body ground
    10 kΩ or higher
    1L-18 (ACT-) or G7-1 - Body ground
    10 kΩ or higher
    E6-30 (LSWP) or G7-7 - Body ground
    10 kΩ or higher

  1. Reconnect the main body ECU connectors.

  1. Reconnect the front door lock assembly RH connector.



NG
REPLACE FRONT DOOR LOCK ASSEMBLY RH (Click here)
OK

REPLACE MAIN BODY ECU


← Only Driver Door LOCK / UNLOCK Functions do not Operate (from Nov 2010)Only Passenger Door LOCK / UNLOCK Functions do not Operate (from Nov 2010) →