TERMINALS OF ECU
System information · Vehicles built from Jul 2007
| CHECK MAIN BODY ECU |
Disconnect the 1B, 1E, 1F, 1L and E6 main body ECU connectors.




Measure the voltage of the wire harness side connectors.
If the result is not as specified, there may be a malfunction on the wire harness side.Standard voltage: Symbols (Terminals No.)
Wiring Color
Terminal Description
Condition
Specified Condition
1B-4 (BECU) - Body ground
W-R - Body ground
Power source (+B)
Always
11 to 14 V
1L-4 (BECU) - Body ground
W-R - Body ground
Power source (+B)
Always
11 to 14 V
1F-12 (BECU) - Body ground
W-R - Body ground
Power source (+B)
Always
11 to 14 V
1E-9 (BDR1) - Body ground
B-Y - Body ground
Power source (+B)
Always
11 to 14 V
E6-23 (MPX2) - Body ground
BR-R - Body ground
Multiplex communication signal
During communication
Signal waveform
| CHECK BACK DOOR ECU |
Disconnect the S2 ECU connector.


Measure the voltage of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.Standard voltage: Symbols (Terminals No.)
Wiring Color
Terminal Description
Condition
Specified Condition
S2-3 (GND) - Body ground
W-B - Body ground
Ground for main power supply
Ground for main power supply
Below 1 V
S2-5 (BECU) - S2-3 (GND)
W-R - W-B
Power source (+B)
Always
11 to 14 V
S2-4 (BDR) - S2-3 (GND)
L-O - W-B
Power source (+B)
Always
11 to 14 V
S2-1 (MPX2) - Body ground
BR-R - Body ground
Multiplex communication signal
During communication
Signal waveform
S2-6 (SIG) - Body ground
B-R - Body ground
Power source (IG)
Ignition switch ON
11 to 14 V