2011-2016 FJ Cruiser · Service Manual COMMUNICATION SYSTEM

B1214 Short to B+ in Door System Communication Bus Malfunction

Diagnostic trouble codes · Vehicles built from Jul 2007

Also covers:

DESCRIPTION

  1. When a +B short circuit or body ground short circuit is detected on the communication bus (BEAN), BEAN is disabled and a DTC is output.
DTC No.
DTC Detection Condition
Trouble Area
B1214
Communication circuit and +B battery system short
  1. Back door ECU
  2. Main body ECU
  3. Wire harness
B1215
Door system communication circuit and body ground short
  1. Back door ECU
  2. Main body ECU
  3. Wire harness

WIRING DIAGRAM

E148137E01

INSPECTION PROCEDURE


1. CHECK DIAGNOSTIC TROUBLE CODE (BACK DOOR ECU)

  1. Disconnect the back door ECU connector and check for DTCs B1214 and B1215.B137555E01

    OK:
    Neither DTC B1214 nor DTC B1215 is output.

    NOTICE:
    Disconnect the connector in the operational sequence, and start the next step after the connector is reconnected.



OK
REPLACE BACK DOOR ECU
NG


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BACK DOOR ECU)

  1. Check for a short-circuit in B+ or body ground.B137554E01

  1. B137571E03
    Disconnect the S2 back door ECU connector and E6 main body ECU connector.
    1. Measure the voltage between the terminals of the S2 back door ECU or E6 main body ECU connector and body ground.

      Standard voltage:
      Tester Connection
      Condition
      Specified Condition
      E6-23 (MPX2) or S2-1 (MPX2) - Body ground
      Ignition switch ON
      Below 1 V

    2. Check the resistance.

      Standard resistance:
      Tester Connection
      Specified Condition
      E6-23 (MPX2) or S2-1 (MPX2) - Body ground
      10 kΩ or higher

  1. Reconnect the back door ECU connector and main body ECU connector.



NG
REPAIR OR REPLACE WIRE HARNESS BETWEEN MAIN BODY ECU AND BACK DOOR ECU
OK

REPLACE MAIN BODY ECU


← DIAGNOSTIC TROUBLE CODE CHART (from Jul 2007)B1287 Back Door ECU Communication Stop (from Jul 2007) →