2011-2016 FJ Cruiser · Service Manual COMMUNICATION SYSTEM

B1287 Back Door ECU Communication Stop

Diagnostic trouble codes · Vehicles built from Jul 2007

DESCRIPTION

DTC B1287 is output when communication between the back door ECU and the main body ECU stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B1287
Back door ECU communication stops
  1. Back door ECU
  2. Wire harness

WIRING DIAGRAM

B137552E02

INSPECTION PROCEDURE


1. CHECK COMMUNICATION LINE

  1. B137571E03
    Disconnect the E6 main body ECU and S2 back door ECU connectors.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E6-23 (MPX2) - S2-1 (MPX2)
    Below 1 Ω

  1. Reconnect the main body ECU and back door ECU connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK BACK DOOR ECU (POWER SOURCE)

  1. B137572E01
    Disconnect the S2 back door ECU connector.

  1. Measure the voltage between the terminals of the S2 back door ECU connector and body ground.

    Standard voltage:
    Tester Connection
    Specified Condition
    S2-5 (BECU) - Body ground
    11 to 14 V

  1. Reconnect the ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK BACK DOOR ECU (GROUND)

  1. B137572E05
    Disconnect the S2 back door ECU connector.

  1. Check the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    S2-3 (GND) - Body ground
    Below 1 Ω

  1. Reconnect the ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BACK DOOR ECU


← B1214 Short to B+ in Door System Communication Bus Malfunction (+ B1215) (from Jul 2007)PRECAUTION (Jul 2007 – Oct 2010) →