2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

A070279E01

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

  1. Remove the service hole cover from the engine under cover.

  1. Install a vinyl hose onto the drain on the radiator side.

  1. Fix the vinyl hose with tape.

  1. A076320E02
    Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.

  1. Remove the radiator cap.

  1. Drain the coolant from the reservoir tank.

  1. Tighten the 3 drain plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf } for the engine

  1. Remove the vinyl hose from the radiator.


3. REMOVE V-BANK COVER

A126474
  1. Remove the 2 nuts, then remove the V-bank cover.


4. REMOVE AIR CLEANER ASSEMBLY

A075594E01
  1. Disconnect the No. 2 ventilation hose.

  1. A075595E01
    Disconnect the vacuum hose.

  1. Disconnect the mass air flow meter connector.

  1. Disengage the 2 wire harness clamps.

  1. A075596E01
    Loosen the 2 hose clamps.

  1. Remove the 2 bolts.

  1. Disconnect the air cleaner hose and remove the air cleaner.


5. REMOVE VVT SENSOR

A076413E02
  1. Bank 1 side VVT sensor:

    1. Disconnect the VVT sensor connector.

    2. Remove the bolt and VVT sensor.

  1. A076414E02
    Bank 2 side VVT sensor:

    1. Disconnect the No. 4 water by-pass hose and No. 5 water by-pass hose.

    2. Disconnect the VVT sensor connector.

    3. A076415E02
      Remove the bolt and VVT sensor.

← COMPONENTS (from Aug 2009)REMOVAL (from Aug 2009) →