C1432 Steering Angle Sensor Power Source Voltage Malfunction
Diagnostic trouble codes · Vehicles built Aug 2011 – Jul 2012
Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
DESCRIPTION
Steering angle sensor signals are sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering angle sensor zero point malfunction diagnostic function.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1432 |
A steering angle sensor power supply malfunction signal is received from the steering angle sensor. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- HINT:
- When the speed sensor or the yaw rate and deceleration sensor has trouble, DTCs for the steering angle sensor may be stored even when the steering angle sensor is normal. When DTCs for the speed sensor or yaw rate and deceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and deceleration sensor first, and then inspect and repair the steering angle sensor.
- When the speed sensor or the yaw rate and deceleration sensor has trouble, DTCs for the steering angle sensor may be stored even when the steering angle sensor is normal. When DTCs for the speed sensor or yaw rate and deceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and deceleration sensor first, and then inspect and repair the steering angle sensor.
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Check for DTCs (Click here).
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|
||||
| A | |
| 2. INSPECT STEERING ANGLE SENSOR (IG, BAT TERMINAL) |
Make sure that there is no looseness in the locking part and connecting part of the connectors.
Disconnect the E16 steering angle sensor connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E16-1 (IG) - Body ground
Ignition switch ON
11 to 14 V
E16-9 (BAT) - Body ground
Always
11 to 14 V
Text in Illustration *a
Front view of wire harness connector
(to Steering Angle Sensor)
|
|
||||
| OK | |
| 3. INSPECT STEERING ANGLE SENSOR (GND TERMINAL) |
Turn the ignition switch off.
Disconnect the E16 steering angle sensor connector.
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
E16-2 (ESS) - Body ground
Always
Below 1 Ω
Text in Illustration *a
Front view of wire harness connector
(to Steering Angle Sensor)
|
|
||||
| OK | ||
| ||
