2011-2016 FJ Cruiser · Service Manual BRAKE

C1432 Steering Angle Sensor Power Source Voltage Malfunction

Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2011

Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012

DESCRIPTION

Steering angle sensor signals are sent to the skid control ECU via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering angle sensor zero point malfunction diagnostic function.
DTC Code
DTC Detection Condition
Trouble Area
C1432
A steering angle sensor power supply malfunction signal is received from the steering angle sensor.
  1. ECU-B fuse
  2. ECU-IG fuse
  3. Steering angle sensor power supply
  4. Steering angle sensor

WIRING DIAGRAM

C185474E08

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
  1. When the speed sensor or the yaw rate and deceleration sensor has trouble, DTCs for the steering angle sensor may be stored even when the steering angle sensor is normal. When DTCs for the speed sensor or yaw rate and deceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and deceleration sensor first, and then inspect and repair the steering angle sensor.


1. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    CAN DTC is not output
    A
    CAN DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2. INSPECT STEERING ANGLE SENSOR (IG, BAT TERMINAL)
  1. Make sure that there is no looseness in the locking part and connecting part of the connectors.

  1. Disconnect the E16 steering angle sensor connector.

  1. C230323E01
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E16-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    E16-9 (BAT) - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Steering Angle Sensor)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK


3. INSPECT STEERING ANGLE SENSOR (GND TERMINAL)
  1. Turn the ignition switch off.

  1. Disconnect the E16 steering angle sensor connector.

  1. C230323E02
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-2 (ESS) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Steering Angle Sensor)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK

REPLACE STEERING ANGLE SENSOR (Click here)


← C1425 Open in Stop Light Switch Circuit (from Aug 2014)C1432 Steering Angle Sensor Power Source Voltage Malfunction (Aug 2011 – Jul 2012) →