REMOVAL
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Jul 2007 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
| 1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Switch A/C ON.
Turn the blower switch to ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.
Stop the engine.
Remove the caps from the service valves on the refrigerant line.


Connect the refrigerant recovery unit.
Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.
- NOTICE:
- Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE RADIATOR GRILLE |
Using a clip remover, remove the 2 clips.

Remove the 2 screws.
Disengage the 5 clips and remove the radiator grille.
| 4. REMOVE FRONT BUMPER COVER |
Apply protective tape as shown in the illustration.

Text in Illustration *a
Protective Tape
Using a clip remover, remove the 5 clips.

Remove the 8 screws and 4 bolts.

Disengage the 2 claws and remove the front bumper cover.

Remove the 4 clips.

| 5. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY |
![]() ![]() |
Remove the bolt and disconnect the discharge hose from the cooler condenser.
Remove the O-ring from the discharge hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
| 6. DISCONNECT AIR CONDITIONING TUBE ASSEMBLY |
![]() ![]() |
Remove the bolt and disconnect the air conditioning tube from the cooler condenser.
Remove the O-ring from the air conditioning tube.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.
| 7. REMOVE COOLER BRACKET |
![]() ![]() |
Remove the nut.
Disengage the clamp and remove the cooler bracket.
| 8. REMOVE NO. 2 COOLER CONDENSER CUSHION LH |
![]() ![]() |
Remove the 2 bolts and remove the cooler condenser cushion.
| 9. REMOVE NO. 2 COOLER CONDENSER CUSHION RH |
![]() ![]() |
Remove the 2 bolts and nut and remove the cooler condenser cushion.
| 10. REMOVE COOLER CONDENSER ASSEMBLY |
![]() ![]() |
Remove the 4 bolts and remove the cooler condenser cushion.
- NOTICE:
- Hold the cooler condenser by hand to prevent it from falling off when removing the cushion.
Remove the condenser from the vehicle.
- NOTICE:
- Do not damage the condenser or radiator when removing the condenser.






