2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014


1. INSTALL EFI FUEL FILTER
  1. Install the fuel filter with the 3 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }


2. CONNECT FUEL MAIN TUBE
  1. Connect the fuel main tube (Click here).

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. If the pipe is difficult to push into the connector, apply a small amount of clean engine oil to the tip of the pipe and reinsert it.
    3. After connecting, check that the pipe and connector are securely connected by pulling on them.


3. CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
  1. Connect the No. 1 fuel pipe sub-assembly (Click here).

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. If the pipe is difficult to push into the connector, apply a small amount of clean engine oil to the tip of the pipe and reinsert it.
    3. After connecting, check that the pipe and connector are securely connected by pulling on them.

  1. Engage the clamp.


4. INSPECT FOR FUEL LEAK
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

    NOTICE:
    Do not start the engine.

  1. Turn the intelligent tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump Speed / ON.

  1. Check fuel pump operation.

    1. Check for pressure in the fuel inlet tube from the fuel line. Check that the sound of fuel flowing in the fuel tank can be heard.
      If there is no sound, check the integration relay, fuel pump, ECM and wiring connector.

← INSTALLATION (Nov 2012 – Jul 2014)COMPONENTS (Jul 2007 – Jul 2009) →