2011-2016 FJ Cruiser · Service Manual DRIVE LINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


CHECK DIFFERENTIAL OIL

D025304E05
  1. Stop the vehicle on a level surface.

  1. Remove the differential filler plug and gasket.

  1. Check that the oil level is between 0 to 5 mm (0 to 0.20 in.) from the bottom lip of the differential filler plug hole.

    NOTICE:
    1. After changing the oil seal, drive the vehicle and then check the oil level again.
    1. Too much or too little oil will lead to differential problems.

    HINT:
    If necessary, fill the differential carrier assembly with hypoid gear oil.


    Front Differential:
    Item
    Temperature
    Oil grade
    Viscosity
    Capacity
    w/ A.D.D.
    -
    Hypoid gear oil API GL-4 or GL-5
    SAE 75W-90
    1.45 to 1.55 liters
    (1.53 to 1.63 US qts, 1.27 to 1.36 Imp. qts.)
    w/o A.D.D.
    Above -18 °C (-0.4 °F)
    SAE 90
    1.35 to 1.45 liters
    (1.42 to 1.53 US qts, 1.18 to 1.27 Imp. qts.)
    Below -18 °C (-0.4 °F)
    SAE 85W-90


    Rear Differential:
    Item
    Temperature
    Oil grade
    Viscosity
    Capacity
    w/o Differential lock
    Above -18 °C (-0.4 °F)
    Hypoid gear oil API GL-5
    SAE 90
    2.95 to 3.05 liters
    (3.12 to 3.22 US qts, 2.60 to 2.68 Imp. qts.)
    Below -18 °C (-0.4 °F)
    SAE 85W-90
    w/ Differential lock
    Above -18 °C (-0.4 °F)
    SAE 90
    2.85 to 2.95 liters
    (3.01 to 3.12 US qts, 2.51 to 2.60 Imp. qts.)
    Below -18 °C (-0.4 °F)
    SAE 85W-90

  1. Check for oil leakage when the oil level is low.

  1. Install the differential filler plug with a new gasket.

    Torque:
    Front differential:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }
    Rear differential:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

← PROBLEM SYMPTOMS TABLE (from Aug 2012)ON-VEHICLE INSPECTION (from Aug 2009) →