2011-2016 FJ Cruiser · Service Manual DRIVE LINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


CHECK DIFFERENTIAL OIL

D025304E05
  1. Stop the vehicle on a level surface.

  1. Remove the differential filler plug and gasket.

  1. Check that the oil level is between 0 to 5 mm (0 to 0.20 in.) from the bottom lip of the differential filler plug hole.

    NOTICE:
    1. After changing the oil seal, drive the vehicle and then check the oil level again.
    1. Too much or too little oil will lead to differential problems.

    HINT:
    If necessary, fill the differential carrier assembly with hypoid gear oil.

    Differential oil type and viscosity:
    Toyota Genuine Differential gear oil LT 75W-85 API GL-5 SAE 75W-85 or equivalent


    Differential Oil Capacity:
    Item
    Capacity
    Front Differential
    w/o A.D.D.
    1.35 to 1.45 Liters
    (1.43 to 1.53 US qts, 1.19 to 1.28 Imp qts.)
    w/ A.D.D.
    1.50 to 1.60 Liters
    (1.59 to 1.69 US qts, 1.32 to 1.41 Imp qts.)
    Rear Differential
    w/o Differential Lock
    2.45 to 2.55 Liters
    (2.59 to 2.69 US qts, 2.16 to 2.24 Imp qts.)
    w/ Differential Lock
    2.40 to 2.50 Liters
    (2.54 to 2.64 US qts, 2.11 to 2.20 Imp qts.)

  1. Check for oil leakage when the oil level is low.

  1. Install the differential filler plug with a new gasket.

    Torque:
    Front differential:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }
    Rear differential:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

← ON-VEHICLE INSPECTION (Jul 2007 – Jul 2009)COMPONENTS (from Jul 2007) →