2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


CLEARANCE WARNING ECU
E149991E04
  1. Disconnect the E76 clearance warning ECU connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E76-10 (IG) - Body ground
    LG - Body ground
    Clearance sonar main switch signal
    Ignition switch ON, back sonar switch ON
    11 to 14 V
    Ignition switch ON, back sonar switch OFF
    Below 1.5 V
    E76-21 (E) - Body ground
    W-B - Body ground
    Body ground
    Always
    Below 1 Ω
    E76-21 (E) - E76-22 (E2)
    W-B - W
    Ground for ultrasonic sensor
    Always
    Below 1 Ω

  3. Reconnect the clearance warning ECU connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E76-3 (SPD) - Body ground
    V-R - W-B
    Vehicle speed signal
    Ignition switch ON, turn drive wheels slowly
    Pulse generation
    E76-6 (SOR) - E76-21 (E)
    B - W-B
    Rear sensor communication signal
    Ignition switch ON, back sonar switch ON
    Pulse generation
    (See waveform 1)
    E76-12 (BBZ) - E76-21 (E)
    L-B - W-B
    Clearance warning buzzer signal
    Buzzer sounding
    Pulse generation
    (See waveform 2)
    E76-13 (RL) - E76-21 (E)
    R-Y - W-B
    Reverse position signal
    Ignition switch ON, shift lever not in R
    Below 1.5 V
    Ignition switch ON, shift lever in R
    7 V or higher
    E76-24 (BOR) - E76-21 (E)
    R-L - W-B
    Power source for rear sensor circuit
    Ignition switch off
    Below 1.5 V
    Ignition switch ON
    7.2 to 8.8 V

  5. Using an oscilloscope, check waveform.

    1. E159890E01
      Waveform 1
      Terminal Connection
      E76-6 (SOR) - E76-21 (E)
      Tester Range
      2 V/DIV., 200 μsec./DIV.
      Vehicle Condition
      Ignition switch ON, back sonar switch ON

    2. E160786E01
      Waveform 2
      Terminal Connection
      E76-12 (BBZ) - E76-21 (E)
      Tester Range
      2 V/DIV., 200 μsec./DIV.
      Vehicle Condition
      Buzzer sounding

← TERMINALS OF ECU (Jul 2007 – Oct 2010)Speed Signal Circuit (Jul 2007 – Jul 2009) →