2011-2016 FJ Cruiser · Service Manual RESTRAINTS

DATA LIST / ACTIVE TEST

System information · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


READ DATA LIST

HINT:
Using an intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Turn the ignition switch off.

  2. Connect an intelligent tester to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the tester on.

  5. Enter the following menus: Body / Body / Data List /

  6. According to the display on tester, read the "Data List".

    Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Seat Buckle SW
    Driver seat belt buckle switch:
    ON or OFF
    ON: Driver seat belt is fastened
    OFF: Driver seat belt is unfastened
    -

← DIAGNOSIS SYSTEM (from Jul 2007)DATA LIST / ACTIVE TEST (from Nov 2010) →