2011-2016 FJ Cruiser · Service Manual RESTRAINTS

DATA LIST / ACTIVE TEST

System information · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


READ DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus: Body / Combination Meter / Data List.

  5. According to the display on the tester, read the Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    P-Seatbelt Buckle SW
    Buckle switch (Front passenger side)/ ON or OFF
    ON: Front passenger side seat belt is fastened
    OFF: Front passenger side seat belt is unfastened
    -
    Driver Side Seatbelt Warning Buzzer
    Driver side seat belt warning buzzer/ ON or OFF
    ON: Driver side seat belt warning buzzer ON
    OFF: Driver side seat belt warning buzzer OFF
    -
    P-Seatbelt Warning Buzzer
    Front passenger side seat belt warning buzzer/ ON or OFF
    ON: Front passenger side seat belt warning buzzer ON
    OFF: Front passenger side seat belt warning buzzer OFF
    -


PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus: Body / Combination Meter / Active Test.

  5. According to the display on the tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Passenger Side Seat Belt
    Front passenger side seat belt warning light
    ON/OFF
    -
    Driver Side Seat Belt
    Driver side seat belt warning light
    ON/OFF
    -

← DATA LIST / ACTIVE TEST (Jul 2007 – Oct 2010)ON-VEHICLE INSPECTION (from Jul 2007) →