2011-2016 FJ Cruiser · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Jul 2007


1. INSTALL TRANSMISSION WIRE

C113707
  1. Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the transmission wire connector.


2. CONNECT TRANSMISSION WIRE

D012704E03
  1. Connect the 7 connectors to the solenoid valves.

  1. Install the 2 clamps with the 2 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf } for bolt A
    11 N*m{ 112 kgf*cm , 8 ft.*lbf } for bolt B

    Bolt length:
    12 mm (0.47 in.) for bolt A
    36 mm (1.42 in.) for bolt B

  1. Connect the ATF temperature sensor.


3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

D028692E01
  1. Install a new O-ring and the oil strainer with the 4 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf }


4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

F051848E01

HINT:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

  1. Install the oil pan with the 20 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }


6. PERFORM INITIALIZATION
(Click here)

7. ADJUST AUTOMATIC TRANSMISSION FLUID
(Click here)
← INSPECTION (from Jul 2007)COMPONENTS (from Jul 2007) →