2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier

Circuit diagnosis · Vehicles built from Nov 2010

DESCRIPTION

The radio receiver assembly sends sound signals to the stereo component amplifier assembly through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.

WIRING DIAGRAM

E219858E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY- STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the E85 radio receiver assembly and K13 stereo component amplifier assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E85-9 (L+) - K13-3 (L+)
    Always
    Below 1 Ω
    E85-19 (L-) - K13-13 (L-)
    Always
    Below 1 Ω
    E85-8 (R+) - K13-4 (R+)
    Always
    Below 1 Ω
    E85-18 (R-) - K13-14 (R-)
    Always
    Below 1 Ω
    E85-9 (L+) - Body ground
    Always
    10 kΩ or higher
    E85-19 (L-) - Body ground
    Always
    10 kΩ or higher
    E85-8 (R+) - Body ground
    Always
    10 kΩ or higher
    E85-18 (R-) - Body ground
    Always
    10 kΩ or higher
    E85-10 (SLD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Speaker Circuit (from Aug 2012)Sound Signal Circuit between Radio Receiver and Multi-media Interface ECU (from Nov 2010) →