2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Radio Receiver and Multi-media Interface ECU

Circuit diagnosis · Vehicles built from Nov 2010

DESCRIPTION

The multi-media interface ECU sends sound signals to the radio receiver assembly through this circuit.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly or speakers.

WIRING DIAGRAM

E219859E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the E86 radio receiver assembly and E84 multi-media interface ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E84-1 (USD1) - E86-1 (CSLD)
    Always
    Below 1 Ω
    E84-2 (URO+) - E86-2 (CDR+)
    Always
    Below 1 Ω
    E84-3 (URO-) - E86-3 (CDR-)
    Always
    Below 1 Ω
    E84-4 (ULO+) - E86-4 (CDL+)
    Always
    Below 1 Ω
    E84-5 (ULO-) - E86-5 (CDL-)
    Always
    Below 1 Ω
    E84-1 (USD1) - Body ground
    Always
    10 kΩ or higher
    E84-2 (URO+) - Body ground
    Always
    10 kΩ or higher
    E84-3 (URO-) - Body ground
    Always
    10 kΩ or higher
    E84-4 (ULO+) - Body ground
    Always
    10 kΩ or higher
    E84-5 (ULO-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier (from Nov 2010)Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (Jul 2007 – Oct 2010) →