2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

REASSEMBLY

Removal / installation · Vehicles built from Jul 2007


1. INSTALL FRONT SHOCK ABSORBER BUSH

C099164E01
  1. Using SST and a press, install a new absorber bush.

    SST
    09710-22021   (09710-01071, 09710-01081)


2. INSTALL FRONT COIL SPRING

C099165E01
  1. Using SST, compress the front coil spring.

    SST
    09727-30021   (09727-00010, 09727-00031)
    09727-00060  

    NOTICE:
    Do not use an impact wrench. It will damage SST.

  1. Install the coil spring onto the shock absorber.

    HINT:
    Fit the lower end of the coil spring into the gap of the spring lower seat.


3. INSTALL FRONT SHOCK ABSORBER CUSHION RETAINER

4. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY

5. INSTALL FRONT SHOCK ABSORBER NO. 1 CUSHION

6. INSTALL FRONT SHOCK ABSORBER CUSHION RETAINER

7. INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

F052437E02
  1. Align the suspension support and the absorber bush as shown in the illustration.

  1. Fit and tighten a new lock nut.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    Do not use an impact wrench. It will damage the shock absorber rod.

  1. Release the coil spring while checking the position of the suspension support.

← INSPECTION (from Jul 2007)INSTALLATION (Jul 2007 – Oct 2010) →