2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012


1. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING

C306469E01
  1. Install the coil spring to the body with the lower end of the coil spring facing the rear side of the vehicle.

    Text in Illustration 
    *1
    Lower End
    *a
    LH Side
    *b
    RH Side
    *c
    Front of the Vehicle

  1. C099160
    Install the 3 nuts to the upper side of the front shock absorber with coil spring.

    Torque:
    71 N*m{ 724 kgf*cm , 52 ft.*lbf }

  1. C099159
    Temporarily tighten the bolt, nut and washer as shown in the illustration.


2. INSTALL TIE ROD END SUB-ASSEMBLY

F043604
  1. Install the tie rod end onto the steering knuckle.

  1. Install the nut.

    Torque:
    91 N*m{ 928 kgf*cm , 67 ft.*lbf }

  1. Install a new cotter pin.

    NOTICE:
    If the holes in the cotter pin are not aligned, tighten the nut an additional 60°.


3. INSTALL FRONT STABILIZER BAR

G020162
  1. Install the stabilizer bar and 2 stabilizer brackets with the 4 bolts.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


4. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

C099158
  1. Install the front stabilizer link assembly LH to the steering knuckle with the nut.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.


5. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
The installation procedure for the RH side is the same as that for the LH side.


6. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY

Torque:
29 N*m{ 296 kgf*cm , 21 ft.*lbf }


7. INSTALL FRONT WHEELS

Torque:
112 N*m{ 1137 kgf*cm , 82 ft.*lbf }


8. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.


9. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING

C099159
  1. Fully tighten the nut.

    Torque:
    95 N*m{ 969 kgf*cm , 70 ft.*lbf }


10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← REASSEMBLY (from Jul 2007)INSTALLATION (Nov 2010 – Oct 2012) →