REASSEMBLY
Removal / installation · Vehicles built Jul 2007 – Jul 2009
Versions by build date: Jul 2007 – Jul 2009 from Aug 2009
| 1. INSTALL MAGNET CLUTCH ASSEMBLY |
![]() ![]() |
Install the magnet clutch stator with the parts shown in the illustration matched.
Using a snap ring expander, install a new snap ring with the chamfered side facing up.

Connect the connector.
Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.

- NOTICE:
- Do not damage the seal cover of the bearing when installing the snap ring.
Install the compressor washer(s) and magnet clutch hub.
- NOTICE:
- Do not change the combination of the compressor washer(s) used before disassembly.
Using magnet clutch stopper, hold the magnet clutch hub and install the bolt.

- Torque:
- 18 N*m{ 184 kgf*cm , 13 ft.*lbf }
- NOTICE:
- Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.
| 2. INSTALL COOLER BRACKET |
![]() ![]() |
Install the cooler bracket with the screw.
Engage the clamp.
| 3. INSPECT MAGNET CLUTCH CLEARANCE |
![]() ![]() |
Clamp the cooler compressor in a vise.
Set the dial indicator to the magnet clutch hub.
Connect the battery positive lead to terminal 3 of the magnet clutch connector and the negative lead to the earth wire. Turn the magnet clutch on and off and measure the clearance.
- Standard clearance:
- 0.35 to 0.60 mm (0.014 to 0.024 in.)
- Compressor spacer thickness:
- 0.1 mm (0.004 in.)
0.3 mm (0.012 in.)
0.5 mm (0.020 in.)
- NOTICE:
- Adjustment should be performed with 3 or fewer magnet clutch washers.
Remove the cooler compressor from the vise.



