2011-2016 FJ Cruiser · Service Manual BODY

ADJUSTMENT

Removal / installation · Vehicles built from Jul 2007

B104980E01

HINT:
  1. Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute standard bolts (with washers) for the centering bolts when making adjustments.
  2. For bolts without torque specifications, check the standard bolt chart (Click here).


1. INSPECT HOOD SUB-ASSEMBLY

  1. Check that the clearance measurements are within the standard ranges.

    B138156E02

    Standard: 
    Area
    Measurement
    A
    4 to 7 mm (0.157 to 0.276 in.)
    B
    1.4 to 4.4 mm (0.055 to 0.173 in.)
    C
    5 to 8 mm (0.197 to 0.315 in.)


2. ADJUST HOOD SUB-ASSEMBLY

B135977
  1. Adjust the hood position.

    1. Loosen the 4 hinge bolts on the hood side.

    2. Move the hood and adjust the clearance between the hood and front fender. Make sure that the clearance is within the standard range.

      Standard(A):
      4.0 to 7.0 mm (0.157 to 0.276 in.)

    3. Tighten the hood side hinge bolts after the adjustment.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. B135976
    Adjust the cushion rubber so that the heights of the hood and the fender are equal.

    1. Raise or lower the hood front end by turning the cushion rubber. Make sure that the clearance is within the standard range.

      HINT:
      Raise or lower the cushion rubber by turning it.

  1. B135978
    Adjust the hood lock.

    1. Disengage the 4 claws and remove the hood lock release lever protector.

    2. B135979
      Loosen the 3 bolts.

    3. B135980
      Adjust the hood lock position so that the striker can enter it smoothly.

    4. B135979
      Tighten the 3 bolts after the adjustment.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    5. B135978
      Engage the 4 claws and install the hood lock release lever protector.

← INSTALLATION (from Jul 2007)COMPONENTS (from Jul 2007) →