INSTALLATION
Removal / installation · Vehicles built from Jul 2007
| 1. INSTALL REAR SEATBACK ASSEMBLY |
Engage the hook and temporarily install the rear seatback with the 2 bolts.

Tighten the 2 bolts in the sequence shown in the illustration.
- Torque:
- 37 N*m{ 375 kgf*cm , 27 ft.*lbf }
Pull up the rear seatback.
Install the rear seat inner belt into the rear seatback holder.

Install the anchor plate of the rear center seat outer belt with the bolt.
- Torque:
- 42 N*m{ 428 kgf*cm , 31 ft.*lbf }
- NOTICE:
- Do not place the anchor plate over the convex area of the rear seat inner belt.
| 2. INSTALL REAR SEATBACK BOARD CARPET ASSEMBLY |
Pull the rear seatback lock release button and tilt the rear seatback forward.

Engage the 10 clips and install the rear seatback board carpet.
Pull up the rear seatback.
| 3. INSTALL REAR SEAT CUSHION ASSEMBLY |
Insert the locating pin into the body hole.

Temporarily install the rear seat cushion with the 2 bolts.
Tighten the 2 bolts in the sequence shown in the illustration.
- Torque:
- 37 N*m{ 375 kgf*cm , 27 ft.*lbf }
