2011-2016 FJ Cruiser · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT WHEEL

3. DRAIN DIFFERENTIAL OIL

4. SEPARATE FRONT SPEED SENSOR

  1. Type A:

    1. C235641
      Using a 5 mm hexagon wrench, remove the bolt and separate the front speed sensor.

    2. Disengage the 3 clamps.

    3. Remove the bolt and separate the skid control sensor wire from the steering knuckle.

  1. Type B:

    1. C235318
      Remove the bolt and separate the front speed sensor.

    2. Disengage the clamp.

    3. Remove the 2 bolts and separate the skid control sensor wire from the steering knuckle.


5. REMOVE FRONT AXLE HUB GREASE CAP

F042729
  1. Using a screwdriver and a hammer, remove the front axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.


6. REMOVE FRONT AXLE HUB NUT

F042732
  1. Remove the cotter pin and adjusting lock cap.

  1. Remove the front axle hub nut.


7. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and nut.

  1. F051679E01
    Using SST, separate the tie rod end from the steering knuckle.
    SST
    09628-62011  


8. SEPARATE FRONT LOWER BALL JOINT ATTACHMENT

G020159
  1. Remove the 2 bolts and separate the front lower ball joint attachment from the steering knuckle.


9. REMOVE FRONT DRIVE SHAFT

F042739E01
  1. Using SST, remove the front drive shaft.

    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    Do not damage the oil seal.

← COMPONENTS (from Aug 2009)DISASSEMBLY (Jul 2007 – Jul 2009) →