2011-2016 FJ Cruiser · Service Manual DRIVE LINE

DISASSEMBLY

Removal / installation · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


1. INSPECT FRONT DRIVE SHAFT

W001721
  1. Check that there is no remarkable play in the outboard joint.

  1. Check that the inboard joint slides smoothly in the thrust direction.

  1. Check that there is no remarkable play in the radial direction of the inboard joint.

  1. Check the boots for damage.

    NOTICE:
    Move the drive shaft while keeping it level.


2. REMOVE FRONT AXLE INBOARD JOINT BOOT NO. 2 CLAMP

F040958
  1. Using a screwdriver, release the staked part of the boot clamp and separate the boot clamp.


3. REMOVE FRONT AXLE INBOARD JOINT BOOT CLAMP

F040959
  1. Using a screwdriver, release the staked part of the boot clamp and separate the boot clamp.


4. SEPARATE INBOARD JOINT BOOT
  1. Separate the inboard joint boot from the inboard joint.


5. REMOVE FRONT DRIVE INBOARD JOINT ASSEMBLY
  1. Remove the old grease from the inboard joint.

  1. FA01615E02
    Place matchmarks on the inboard joint, tripod and outboard joint shaft.

    NOTICE:
    Do not punch the marks.

  1. Remove the inboard joint from the outboard joint shaft.

  1. Fix the outboard joint shaft in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. G022501
    Using a snap ring expander, remove the snap ring.

  1. N000194E02
    Place matchmarks on the outboard joint shaft and tripod.

    NOTICE:
    Do not punch the marks.

  1. Using a brass bar and hammer, remove the tripod from the outboard joint shaft.

    NOTICE:
    Do not tap the roller.

  1. Remove the inboard joint boot No. 2 clamp, the inboard joint boot and the inboard joint boot clamp.


6. REMOVE FRONT AXLE OUTBOARD JOINT BOOT NO. 2 CLAMP

C063445
  1. Using a screwdriver, release the staked part of the boot clamp and remove the boot clamp.


7. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP

C081566
  1. Using pliers, remove the boot clamp, as shown in the illustration.


8. REMOVE OUTBOARD JOINT BOOT
  1. Remove the outboard joint boot from the outboard joint shaft.

  1. Remove the old grease from the outboard joint.


9. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING

C057543
  1. Using a screwdriver, remove the snap ring.


10. REMOVE FRONT DRIVE SHAFT DUST COVER

F040647E01
  1. Using SST and a press, remove the dust cover.

    SST
    09950-00020  

← REMOVAL (from Jul 2007)DISASSEMBLY (from Aug 2009) →