2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT WHEEL

3. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with painted surfaces.


4. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY

F042731
  1. Remove the bolt and separate the brake tube bracket from the steering knuckle.

  1. F050777E01
    Using SST, separate the brake tube from the disc brake cylinder.
    SST
    09023-00101  

    HINT:
    Use a container to collect the brake fluid as it drains out.

  1. F050211
    Remove the 2 bolts and disc brake caliper assembly.


5. REMOVE FRONT DISC
  1. Place matchmarks on the disc and the axle hub and remove the disc.


6. SEPARATE FRONT SPEED SENSOR

  1. Type A:

    1. C235641
      Using a 5 mm hexagon wrench, remove the bolt and separate the front speed sensor.

    2. Disengage the 3 clamps.

    3. Remove the bolt and separate the skid control sensor wire from the steering knuckle.

  1. Type B:

    1. C235318
      Remove the bolt and separate the front speed sensor.

    2. Disengage the clamp.

    3. Remove the 2 bolts and separate the skid control sensor wire from the steering knuckle.


7. REMOVE FRONT AXLE HUB GREASE CAP

F042729
  1. Using a screwdriver and a hammer, remove the front axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.


8. REMOVE FRONT AXLE HUB NUT

F042732
  1. Remove the cotter pin and adjusting lock cap.

  1. Remove the front axle hub nut.


9. SEPARATE FRONT STABILIZER LINK ASSEMBLY

C099158
  1. Remove the nut and separate the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.


10. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and nut.

  1. F051679E01
    Using SST, separate the tie rod end from the steering knuckle.
    SST
    09628-62011  


11. SEPARATE FRONT LOWER BALL JOINT ATTACHMENT

G020159
  1. Remove the 2 bolts and separate the front lower ball joint attachment from the steering knuckle.


12. SEPARATE FRONT UPPER SUSPENSION ARM
  1. Support the lower arm with a jack.

  1. Remove the clip and nut.

  1. G020151E01
    Using SST, separate the upper ball joint from the steering knuckle.
    SST
    09628-62011  


13. REMOVE FRONT AXLE ASSEMBLY
  1. for 4WD:

    1. Using a plastic hammer, separate the front axle hub from the front drive shaft.

  1. Remove the front axle assembly.

← COMPONENTS (from Jul 2007)DISASSEMBLY (from Jul 2007) →