2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Nov 2012

Versions by build date: Jul 2007 – Oct 2012 from Nov 2012


1. INSTALL FRONT AXLE HUB BOLT

C098706E01
  1. Install the washer and the nut onto a new hub bolt, as shown in the illustration.

  1. Using a screwdriver or the equivalent to hold the axle hub, install the hub bolt by tightening the nut.


2. INSTALL FRONT DISC
  1. Align the matchmarks of the disc and axle hub and install the disc.

    HINT:
    When replacing the disc, select the position that gives the minimum disc runout.


3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

  1. F050211
    Install the front disc brake caliper assembly with the 2 bolts.

    Torque:
    123 N*m{ 1254 kgf*cm , 91 ft.*lbf }

  1. F042731
    Install the brake tube bracket to the steering knuckle with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

  1. F050777
    Using a union nut wrench 10 mm, install the brake tube to the front disc brake caliper assembly.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (Click here).


4. BLEED BRAKE LINE
  1. Turn the ignition switch to ON.

  1. Remove the brake master cylinder reservoir filler cap assembly.

  1. Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.

  1. Repeatedly depress the brake pedal and bleed air from the bleeder plug of the front disc brake cylinder RH.

  1. Repeat the step above until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.

  1. With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates.

    HINT:
    1. Air is bled as the pump motor operates while the brake pedal is being depressed.
    2. Be sure to release the brake pedal to stop the motor after approximately 100 seconds of continuous operation.
    3. As brake fluid is continuously drained while the pump operates, it is not necessary to repeatedly depress the brake pedal.

  1. When there is no more air in the brake fluid, tighten the bleeder plug, and then release the brake pedal.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

  1. Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.

  1. Turn the ignition switch off.

  1. Inspect for brake fluid leaks.

  1. Check and adjust the brake fluid level (Click here).

  1. Clear the DTCs (Click here).


5. INSTALL FRONT WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 82 ft.*lbf }

← INSTALLATION (Jul 2007 – Oct 2012)COMPONENTS (from Jul 2007) →