DTC CHECK / CLEAR
Troubleshooting · Vehicles built Jul 2007 – Jul 2008
Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
| DTC CHECK (for Using an Intelligent Tester) |
Check DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Select the following menu items: Chassis / ABS/VSC/TRC / Trouble Codes
Read the DTCs by following the prompts on the intelligent tester.
| DTC CLEAR (for Using an Intelligent Tester) |
Clear DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Select the following menu items: Chassis / ABS/VSC/TRC / Trouble Codes
Clear the DTCs by following the prompts on the intelligent tester.
| DTC CHECK (for Using a SST Check Wire) |
Check DTCs.
Using SST, connect terminals TC and CG of the DLC3.

- SST
- 09843-18040
Turn the ignition switch to ON.
Read 2-digit DTCs by observing the blinking of the ABS warning light and the VSC TRC warning light on the combination meter.
- HINT:
- If no code appears, inspect the ABS warning light circuit, VSC TRC warning light circuit or TC and CG terminal circuit.
Trouble Area
See page
ABS warning light circuit
Click here
Click here
VSC TRC warning light circuit
Click here
Click here
TC and CG terminal circuit
Click here
- As an example, the blinking patterns of the normal system indication and DTCs 11 and 21 are shown below.


- DTCs are explained in DTC chart (Click here).
- If no code appears, inspect the ABS warning light circuit, VSC TRC warning light circuit or TC and CG terminal circuit.
After completing the check, disconnect SST from terminals TC and CG of the DLC3, and turn the ignition switch off.
If 2 or more malfunctions are detected at the same time, the lowest numbered DTC is displayed first.
| DTC CLEAR (for Using a SST Check Wire) |
Clear DTCs.
Using SST, connect terminals TC and CG of the DLC3.

Turn the ignition switch to ON.
- SST
- 09843-18040
Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

Check that the ABS warning light and VSC TRC warning light blink in normal code pattern.
Remove SST from the terminals of the DLC3.
Turn the ignition switch off.
- HINT:
- Clearing the DTCs cannot be performed by removing the battery cable.
| END OF DTC CHECK/CLEAR |
Turn the ignition switch to ON.
Check that the ABS warning light and VSC TRC warning light go off within approximately 3 seconds.
Turn the ignition switch off.