2011-2016 FJ Cruiser · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.


3. REMOVE FRONT DISC BRAKE ANTI RATTLE WITH HOLE PIN

F043185
  1. Remove the 2 pin hold clips, then remove the 2 hole pins from the disc brake cylinder.

  1. Remove the anti rattle spring from the disc brake pad.


4. REMOVE FRONT DISC BRAKE PAD
  1. Remove the 2 disc brake pads with anti squeal shims from the disc brake cylinder.


5. REMOVE FRONT ANTI SQUEAL SHIM KIT
  1. Remove the No. 1 and No. 2 anti squeal shims from each of the disc brake pads.


6. REMOVE DISC BRAKE CYLINDER ASSEMBLY

C168980
  1. Using a union nut wrench, separate the brake tube from the disc brake cylinder.

    HINT:
    Use a container to collect the brake fluid as it drains out.

  1. F050211
    Remove the 2 bolts and disc brake cylinder.


7. REMOVE FRONT DISC
  1. Place matchmarks on the disc and the axle hub and remove the disc.

← COMPONENTS (from Jul 2007)DISASSEMBLY (from Jul 2007) →