2011-2016 FJ Cruiser · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Jul 2007


1. REMOVE CYLINDER BOOT

F043024
  1. Using a screwdriver, remove the 4 set rings and 4 cylinder boots from the disc brake cylinder.


2. REMOVE FRONT DISC BRAKE PISTON

F042676E02
  1. Prepare a wooden plate to hold the pistons.

  1. F042677
    Place the plate between the pistons and insert a pad into one side.

  1. Apply compressed air to remove the pistons one side at a time from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when applying compressed air.

    NOTICE:
    Do not spatter the brake fluid.


3. REMOVE PISTON SEAL

F042678
  1. Using a screwdriver, remove the 4 piston seals from the cylinder.

    NOTICE:
    Do not damage the inner surface or piston seal groove of the cylinder.


4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP

5. REMOVE FRONT DISC BRAKE BLEEDER PLUG
← REMOVAL (from Jul 2007)INSPECTION (from Jul 2007) →