2011-2016 FJ Cruiser · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jul 2007


1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG

2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

3. INSTALL PISTON SEAL
  1. Apply lithium soap base glycol grease to 4 new piston seals.

  1. Install the 4 piston seals onto the disc brake cylinder.

    NOTICE:
    Securely install the piston seal into the groove of the disc brake cylinder.


4. INSTALL FRONT DISC BRAKE PISTON

C111385E01
  1. Apply lithium soap base glycol grease to the 4 disc brake pistons and 4 new cylinder boots.

  1. Install the 4 cylinder boots to the 4 disc brake pistons.

  1. Install the 4 disc brake pistons onto the disc brake cylinder.

    NOTICE:
    Do not forcibly install the piston into the disc brake cylinder.


5. INSTALL CYLINDER BOOT

C111386
  1. Install the 4 cylinder boots onto the disc brake cylinder.

    NOTICE:
    Securely install the cylinder boot into the grooves of the disc brake cylinder and piston.

  1. Using a screwdriver, install 4 new set rings.

    NOTICE:
    Do not damage the boot.

← INSPECTION (from Jul 2007)INSTALLATION (from Jul 2007) →