2011-2016 FJ Cruiser · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Jul 2007


1. REMOVE BRAKE ACTUATOR NO. 1 BRACKET

F051421
  1. Using a 5 mm hexagon wrench, remove the bolt and brake actuator bracket.

  1. F051180
    Using a screwdriver, remove the fluid level warning switch connector.


2. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

F051177
  1. Using a pin punch and hammer, remove the pin from the master cylinder reservoir.

  1. F051178E01
    Remove the screw and pull out the master cylinder reservoir.

  1. F051181E01
    Remove the 3 grommets from the master cylinder reservoir.


3. REMOVE BRAKE ACTUATOR HOSE NO.1

F051182E01
  1. Using needle-nose pliers, slide the 2 clips and remove the brake actuator hose.


4. REMOVE BRAKE ACTUATOR NO. 1 TUBE

C168978
  1. Using a union nut wrench, remove the brake actuator tube.


5. REMOVE BRAKE BOOSTER WITH ACCUMULATOR PUMP ASSEMBLY

F051519E02
  1. Using a screwdriver, remove the 2 plugs.

  1. F051520E02
    Remove the 2 screws and pull the wire harness.

  1. F051521
    Using a screwdriver, remove the clip.

  1. F051188
    Remove the brake booster with accumulator pump assembly.

  1. Remove the 2 bushes and 2 collars from the brake booster with accumulator pump assembly.

  1. F051415E01
    Using a 4 mm hexagon wrench, remove the 2 pins.


6. REMOVE BRAKE ACTUATOR BRACKET

F051423
  1. Using a 5 mm hexagon wrench, remove the bolt and brake actuator bracket.


7. REMOVE BRAKE BOOSTER PUMP BRACKET

F051189E01
  1. Using a 5 mm hexagon wrench, remove the 2 bolts and the brake booster pump bracket.

  1. Remove the bush from the brake booster pump bracket.


8. REMOVE MASTER CYLINDER SOLENOID

F051195E01
  1. Remove the 6 bolts and the master cylinder solenoid.

  1. F051196
    Remove the gasket.


9. REMOVE MASTER CYLINDER PUSH ROD CLEVIS

F051191E01
  1. Loosen the lock nut on the rod operating adapter, and then remove the push rod clevis and lock nut.

  1. F051192E01
    Loosen the lock nut on the brake master cylinder side, and then remove the rod operating adapter and lock nut.


10. REMOVE MASTER CYLINDER BOOT

11. REMOVE PISTON

F051417E01
  1. When pressing in the piston with a screwdriver, use a pin or the equivalent to push the C-ring from the hole in the master cylinder body. Then remove the C-ring with another screwdriver.

  1. Remove the piston by pulling it straight out, not at an angle.

    NOTICE:
    If the piston is pulled out at an angle, there is a possibility that the cylinder bore could be damaged.


12. REMOVE BRAKE BOOSTER ACCUMULATOR ASSEMBLY

F051527
  1. Place the brake booster with accumulator pump assembly in a vise lined with a cloth.

  1. Remove the brake booster accumulator.

  1. Remove the brake booster accumulator pipe, compression spring and O-ring.

← REMOVAL (from Aug 2012)INSPECTION (from Jul 2007) →