INSTALLATION
Removal / installation · Vehicles built Nov 2010 – Jul 2014
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014
| 1. INSTALL VANE PUMP |
Install the vane pump assembly with the 2 bolts.
- Torque:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }
| 2. INSTALL NO. 1 OIL RESERVOIR TO PUMP HOSE |
Connect the No. 1 oil reservoir to pump hose with the clip.
| 3. INSTALL PRESSURE FEED TUBE ASSEMBLY |
Install a new gasket onto the pressure feed tube.
Install the pressure feed tube with the union bolt.
- Torque:
- 50 N*m{ 510 kgf*cm , 37 ft.*lbf }
Install the wire harness clamp bracket with the bolt.
- Torque:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }
Connect the oil pressure switch connector.
- NOTICE:
- Make sure that no oil adheres to the connector.
| 4. INSTALL FAN AND GENERATOR V BELT |
Set the V belt onto every part.

Text in Illustration *1
Vane Pump
*2
Water Pump
*3
No. 2 Idler
*4
Generator
*5
Cooler Compressor or Idler Pulley
*6
No. 1 Idler
*7
Crankshaft
*8
V-Ribbed Belt Tensioner
While turning the belt tensioner counterclockwise, remove the pin.
- NOTICE:
- Make sure that the V belt is properly installed to each pulley.
Check that the belt fits properly in the ribbed grooves.
- HINT:
- Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.
| 5. INSTALL FRONT FENDER APRON SEAL RH |
Install the frame seal with the 5 clips.
| 6. INSTALL V-BANK COVER |
Engage the 2 V-bank cover hooks to the bracket.
Align the 2 V-bank cover grommets with the 2 pins and press down on the V-bank cover to engage the pins.
| 7. ADD POWER STEERING FLUID |
| 8. BLEED POWER STEERING FLUID |
Check the fluid level.
Jack up the front of the vehicle and support it with stands.
Turn the steering wheel.
With the engine stopped, turn the wheel slowly from lock to lock several times.
Lower the vehicle.
Start the engine.
Run the engine at idle for a few minutes.
Turn the steering wheel.
With the engine idling, turn the wheel to the left or right full lock position and keep it there for 2 to 3 seconds. Then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds (step A).
Repeat step A several times.
Stop the engine.
Check for foaming or emulsification.

Especially, if the system has to be bled twice because of foaming or emulsification, check for fluid leakage in the system.Text in Illustration *a
Normal
*b
Abnormal
Check the fluid level.
| 9. INSPECT FOR POWER STEERING FLUID LEAK |
| 10. INSTALL FRONT WHEEL RH |
- Torque:
- 112 N*m{ 1137 kgf*cm , 82 ft.*lbf }
