2011-2016 FJ Cruiser · Service Manual STEERING

INSPECTION

Inspection · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


INSPECT OIL CLEARANCE

F051269E02
  1. Using a micrometer and caliper gauge, measure the oil seal clearance.

    Standard clearance:
    0.021 to 0.043 mm (0.0008 to 0.0017 in.)

    Maximum clearance:
    0.07 mm (0.0028 in.)

    If it is greater than the maximum, replace the vane pump assembly.


INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE

N000372E03
  1. Using a micrometer, measure the height, thickness and length of the vane plates.

    Minimum height:
    7.6 mm (0.299 in.)

    Minimum thickness:
    1.405 mm (0.0553 in.)

    Minimum length:
    11.993 mm (0.4722 in.)

  1. R010282E01
    Using a feeler gauge, measure the clearance between a side face of the vane pump rotor groove and vane plate.

    Maximum clearance:
    0.025 mm (0.0010 in.)

    If it is greater than the maximum, replace the vane pump assembly.


INSPECT FLOW CONTROL VALVE

F051270
  1. Coat the flow control valve with power steering fluid and check that it falls smoothly into the flow control valve hole under its own weight.

  1. F052069E02
    Check the flow control valve for leakage. Close one of the holes and apply compressed air of 392 to 490 kPa (4 to 5 kgf/cm2, 57 to 71 psi) to the hole on the opposite side. Confirm that the air does not flow out from the end holes.
    If necessary, replace the vane pump assembly.


INSPECT COMPRESSION SPRING

R008702E02
  1. Using vernier calipers, measure the free length of the spring.

    Minimum free length:
    29.2 mm (1.150 in.)

    If it is not within the specification, replace the vane pump assembly.


INSPECT PRESSURE PORT UNION SUB-ASSEMBLY
  1. If the union seat in the pressure port union is badly damaged, it could cause fluid leakage, so replace the vane pump assembly.

← DISASSEMBLY (from Aug 2009)INSPECTION (from Aug 2009) →