DISASSEMBLY
Removal / installation · Vehicles built from Aug 2009
Versions by build date: Jul 2007 – Jul 2009 from Aug 2009
| 1.
FIX VANE PUMP |
 |
Using SST, fix the vane pump assembly in a vise.
- SST
- 09630-00014
(09631-00132)
- NOTICE:
- Do not overtighten the vise.
| 2.
REMOVE POWER STEERING SUCTION PORT UNION |
 |
- Remove the bolt and suction port union.
Remove the O-ring from the suction port union.
| 3.
REMOVE PRESSURE FEED TUBE |
 |
- Remove the bolt and pressure feed tube.
Remove the 2 gaskets from the pressure feed tube.
| 4.
REMOVE FLOW CONTROL VALVE |
 |
- Remove the pressure port union.
Remove the O-ring from the pressure port union.
Remove the flow control valve and compression spring.
| 5.
REMOVE VANE PUMP REAR HOUSING |
 |
- Remove the 4 bolts and vane pump housing rear from the vane pump housing front.
- Remove the O-ring from the vane pump housing front.
Text in Illustration
*1
|
Protective Tape
|
| 6.
REMOVE PULLEY SHAFT SUB-ASSEMBLY |
 |
- NOTICE:
- Be careful not to drop or damage the pulley shaft. If damaged, replace it with a new one.
- Using a screwdriver, remove the snap ring from the pulley shaft.
Remove the pulley shaft.
| 7.
REMOVE VANE PUMP ROTOR |
 |
- Remove the 10 vane plates.
Remove the vane pump rotor.
| 8.
REMOVE VANE PUMP CAM RING |
 |
- Remove the vane pump cam ring.
| 9.
REMOVE VANE PUMP FRONT SIDE PLATE |
 |
Remove the side plate from the vane pump housing front.
Remove the O-ring from the side plate.
- Remove the O-ring from the vane pump housing front.
| 10.
REMOVE VANE PUMP HOUSING OIL SEAL |
 |
Using screwdriver, remove the oil seal.
- NOTICE:
- Be careful not to damage the vane pump housing front.