REASSEMBLY
Removal / installation · Vehicles built from Jul 2007
| 1. INSTALL RELEASE CYLINDER BLEEDER PLUG |
- Torque:
- 11 N*m{ 110 kgf*cm , 8 ft.*lbf }
| 2. INSTALL CLUTCH RELEASE CYLINDER KIT |
Install the bleeder plug cap onto the bleeder plug.
Install 2 new cylinder cups onto the piston.
Install the spring onto the cylinder body.
Apply lithium soap base glycol grease to the portions shown in the illustration.

Install the piston onto the cylinder body.
- NOTICE:
- Do not damage the inside of the cylinder body.
Install the push rod into the cylinder body.
Install the boot onto the cylinder body.
