INSTALLATION
Removal / installation · Vehicles built from Aug 2009
Versions by build date: Jul 2007 – Jul 2009 from Aug 2009
| 1. INSTALL FAN AND GENERATOR V BELT |
Set the V belt onto every part.

Text in Illustration *1
Vane Pump
*2
Water Pump
*3
No. 2 Idler
*4
Generator
*5
Cooler Compressor or Idler Pulley
*6
No. 1 Idler
*7
Crankshaft
*8
V-Ribbed Belt Tensioner
While turning the belt tensioner counterclockwise, remove the pin.
- NOTICE:
- Make sure that the V belt is properly installed to each pulley.
Check that the belt fits properly in the ribbed grooves.
- HINT:
- Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.
