ON-VEHICLE INSPECTION
Inspection · Vehicles built Jul 2007 – Jul 2009
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Jul 2011 from Aug 2011
| CHECK ENGINE OIL LEVEL |
Warm up the engine, then stop the engine and wait for 5 minutes.
Check that the engine oil level is between the low level and full level marks on the level gauge.
If low, check for leakage and top oil up to the full level mark.- NOTICE:
- Do not fill with engine oil to above the full level mark.
| CHECK ENGINE OIL QUALITY |
Check the oil for deterioration, water intrusion, discoloration or thinning.
If the quality is visibly poor, replace the oil.
| INSPECT OIL PRESSURE |
Disconnect the oil pressure switch connector.
Using a 24 mm deep socket wrench, remove the oil pressure switch.

Install the oil pressure gauge.
Warm up the engine.
Inspect the oil pressure.
- Oil pressure:
Engine condition
Specification
When Idling
29 kPa (0.3 kgf*cm2, 4.3 psi) or more
At 3,000 rpm
294 to 588 kPa (3.0 to 6.0kgf*cm2, 43 to 85 psi)
Apply adhesive to 2 or 3 threads of the oil pressure switch.

- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or the equivalent
Using a 24 mm deep socket wrench, install the oil pressure switch.
- Torque:
- 15 N*m{ 153 kgf*cm , 11 ft.*lbf }
- NOTICE:
- Do not start the engine within 1 hour of the installation.
Connect the oil pressure switch connector.
Check for engine oil leakage.
