ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2011
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Jul 2011 from Aug 2011
| CHECK OIL QUALITY |
Check the oil for deterioration, water contamination, discoloring or thinning.
If the quality is visibly poor, replace the oil and oil filter element (Click here).
| CHECK ENGINE OIL LEVEL |
Warm up the engine, then stop the engine and wait for 5 minutes.
Check that the engine oil level is between the low level and full level marks on the dipstick.
If low, check for leakage and add oil up to the full level mark.- NOTICE:
- Do not fill engine oil above the full level mark.
| INSPECT OIL PRESSURE |
Remove the oil pressure switch (Click here).
Install an oil pressure gauge.

Text in Illustration *1
Oil pressure Gauge
Warm up the engine.
Inspect the oil pressure.
- Standard Oil Pressure:
Condition
Specified Condition
Idling
29 kPa (0.3 kgf/cm2, 4.2 psi) or more
3000 rpm
294 to 588 kPa (3.0 to 6.0 kgf/cm2, 43 to 85 psi)
Remove the oil pressure gauge.
Install the oil pressure switch (Click here).
