2011-2016 FJ Cruiser · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009

HINT:
  1. Thoroughly clean all parts to be assembled.
  2. Before installing the parts, apply new engine oil to all sliding and rotating surfaces.
  3. Replace all gaskets, O-rings and oil seals with new parts.


1. REMOVE VALVE LIFTER

A075601E01

HINT:
Arrange the valve lifter in the correct order.


2. REMOVE VALVE

A075602E03

HINT:
Arrange the valves, inner compression springs, valve spring retainers and valve spring retainer locks in the correct order.

  1. Place the cylinder head on a wooden block.

  1. Using SST, compress the inner compression spring and remove the 2 valve spring retainer locks.

    SST
    09202-70020   (09202-00010)

  1. Remove the valve, inner compression spring and valve spring retainer.


3. REMOVE VALVE SPRING SEAT

A075603E01
  1. Using compressed air and a magnetic finger, remove the valve spring seat by applying compressed air.


4. REMOVE VALVE STEM OIL O SEAL OR RING

A075604E01
  1. Using needle-nose pliers, remove the valve stem oil seal.


5. REMOVE STRAIGHT PIN NO.1
  1. Remove the 10 knock pins from bank 1 and bank 2 cylinder heads.


6. REMOVE EXHAUST MANIFOLD, RH STUD BOLT

  1. Remove the 20 stud bolts from bank 1 and bank 2 cylinder heads.

    A126358E02


7. REMOVE UNION

  1. Remove the 2 unions from bank 1 and bank 2 cylinder heads.

    A126360E02


8. REMOVE TIGHT PLUG

  1. Remove the 2 tight plugs from bank 1 and bank 2 cylinder heads.

    A126362E02

← REMOVAL (Jul 2007 – Jul 2009)DISASSEMBLY (from Aug 2009) →