2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Nov 2010 – Jul 2014

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014

HINT:
  1. Use these procedures to troubleshoot the power door lock control system.
  2. *: Use an intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK
      NEXT

      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace battery before proceeding.
      NEXT

      4.INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)*
      1. Use the intelligent tester to check if the Multiplex Communication System (MPX) is functioning normally.

        Result 
        Result
        Proceed to
        MPX DTC is not output
        A
        MPX DTC is output
        B


      B.
      A

      5.PROBLEM SYMPTOMS TABLE
        Result 
        Result
        Proceed to
        If fault is not listed in problem symptoms table
        A
        If fault is listed in problem symptoms table
        B

      B.
      A

      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Terminals of ECU (Click here)

      2. Data List / Active Test (Click here)

      NEXT

      7.REPAIR OR REPLACE
        NEXT

        8.CONFIRMATION TEST
          NEXT

          ← HOW TO PROCEED WITH TROUBLESHOOTING (Jul 2007 – Oct 2010)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014) →