2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Jul 2014 from Aug 2014


CHECK MAIN BODY ECU
B136051E01
B136052E01
  1. Disconnect the 1A, 1B, 1E, and 1H main body ECU (driver side junction block) connectors.

  2. Measure the voltages and resistances of the wire harness side connectors.

    Standard: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND1 (1H-2) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    BECU (1B-4) - Body ground
    W-R - Body ground
    Power source circuit (From battery)
    Always
    11 to 14 V
    BDR1 (1E-9) - Body ground
    B-Y - Body ground
    Power source circuit (From battery)
    Always
    11 to 14 V
    GND2 (1A-7) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the main body ECU (driver side junction block) connectors.

  4. Measure the voltages of the wire harness side connectors.

    Standard voltage: 
    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    SIG - (1F-8) Body ground
    B-R - Body ground
    Ignition switch signal
    Ignition switch OFF
    Below 1 V
    Ignition switch ON
    10 to 14 V
    ILE (1A-8) - Body ground
    W - Body ground
    Illumination signal (To room light assembly)
    Driver door closed
    10 to 14 V
    Driver door open
    Below 1 V
    HRLY (1B-8) - Body ground
    Y-P - Body ground
    HEAD signal (To HEAD relay)
    Light control switch OFF or in TAIL
    10 to 14 V
    Light control switch in HEAD
    Below 1 V
    TRLY (1E-16) - Body ground
    V - Body ground
    TAIL signal (To TAIL relay)
    Light control switch OFF
    10 to 14 V
    Light control switch in TAIL or HEAD
    Below 1 V
    ACC (1D-5) - Body ground
    W-G - Body ground
    Ignition switch (From battery) ACC signal circuit (To ignition switch)
    Ignition switch OFF
    Below 1 V
    Ignition switch ACC
    10 to 14 V
    LMRY (E6-3) - Body ground
    GR-R - Body ground
    DOME relay output signal (To DOME relay)
    All doors locked
    10 to 14 V
    Any door open
    Below 1 V
    DIM* (E6-7) - Body ground
    R-G* - Body ground
    DIM relay output signal (To DIM relay)
    Dimmer switch in FLASH or HIGH
    Below 1 V
    Dimmer switch in LOW
    10 to 14 V
    BCTY (E7-7) - Body ground
    W - Body ground
    Back door courtesy switch and back window courtesy switch input
    Back door or back window open
    Below 1 V
    Back door and back window closed
    11 to 14 V
    RLCY (E7-11) - Body ground
    P-B - Body ground
    Rear LH door courtesy switch input
    Rear LH door open
    Below 1 V
    Rear LH door closed
    11 to 14 V
    RRCY (E7-12) - Body ground
    P-L - Body ground
    Rear RH door courtesy switch input
    Rear RH door open
    Below 1 V
    Rear RH door closed
    11 to 14 V
    DCTY (E7-23) - Body ground
    R-B - Body ground
    Driver door courtesy switch input
    Driver door open
    Below 1 V
    Driver door closed
    11 to 14 V
    PCTY (E7-24) - Body ground
    G-Y - Body ground
    Front passenger door courtesy switch input
    Front passenger door open
    Below 1 V
    Front passenger door closed
    11 to 14 V
    HEAD (E8-1) - Body ground
    R - Body ground
    Light control switch (HEAD signal)
    Light control switch OFF
    11 to 14 V
    Light control switch is ON
    Below 1 V
    HF (E8-7) - Body ground
    R-W - Body ground
    Headlight dimmer switch (FLASH signal)
    Headlight dimmer switch in FLASH
    Below 1 V
    Headlight dimmer switch in LOW or HIGH
    11 to 14 V
    TAIL (E8-8) - Body ground
    G - Body ground
    Light control switch (TAIL signal)
    Light control switch in TAIL
    Below 1 V
    Light control switch OFF
    11 to 14 V
    DRLP (E8-12) - Body ground
    V-Y - Body ground
    Open door warning light output
    Open door warning light ON
    Below 1.2 V
    Open door warning light OFF
    10 to 14 V
    HF2 (E8-20) - Body ground
    Y-P - Body ground
    Headlight dimmer switch (FLASH signal)
    Headlight dimmer switch in FLASH
    Below 1 V
    Headlight dimmer switch in LOW or HIGH
    10 to 14 V
    If the result is not as specified, there may be a malfunction in the wire harness.

← PROBLEM SYMPTOMS TABLE (from Aug 2014)TERMINALS OF ECU (Nov 2010 – Jul 2012) →