2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Headlight Relay Circuit

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

The headlight dimmer switch sends a signal to the main body ECU.

WIRING DIAGRAM

E153826E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HEAD LIGHT)
  1. Connect the intelligent tester to DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Body Electrical / Body / Active Test / Headlight Relay

  1. Check the headlight (Low-beam) while operating the headlight relay using the tester.

    Body (Main Body ECU):
    Tester Display
    Test Part
    Control Range
    Normal Condition
    Head Light
    Headlight Relay
    ON/OFF
    -

    OK:
    The headlight (Low-beam) comes on when operating it through the intelligent tester.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
NG


2. INSPECT HEADLIGHT RELAY

  1. E109076E03
    Remove the HEAD relay from the No. 2 engine room relay block.

  1. Measure the resistance according value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply the battery voltage between terminals 1 and 2
    Below 1 Ω

  1. Reinstall the HEAD relay.



NG
REPLACE HEADLIGHT RELAY
OK


3. CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT RELAY)
B136078E02
  1. Remove the HEAD relay from the No. 2 engine room relay block.

  1. Measure the voltage according value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    HEAD relay terminal 1 - Body ground
    Always
    11 to 14 V

  1. Reinstall the HEAD relay.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY - MAIN BODY ECU)

  1. B136079E02
    Remove the HEAD relay from the No.2 engine room relay block.

  1. Disconnect the 1B main body ECU connector.

  1. Measure the resistance according value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    HEAD relay terminal 2 - 1B-8 (HRLY)
    Always
    Below 1 Ω
    HEAD relay terminal 2 or 1B-8 (HRLY) - Body ground
    Always
    10 kΩ or higher

  1. Reinstall the HEAD relay.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Stop Light Switch Circuit (from Nov 2010)Headlight Relay Circuit (from Nov 2010) →