Headlight Relay Circuit
Circuit diagnosis · Vehicles built from Nov 2010
Versions by build date: Jul 2007 – Oct 2010 from Nov 2010
DESCRIPTION
The headlight dimmer switch sends a signal to the main body ECU.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HEAD LIGHT) |
 |
Connect the intelligent tester to DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Body / Active Test / Headlight Relay
Check the headlight (Low-beam) while operating the headlight relay using the tester.
- Body (Main Body ECU):
Tester Display
|
Test Part
|
Control Range
|
Normal Condition
|
Head Light
|
Headlight Relay
|
ON/OFF
|
-
|
- OK:
- The headlight (Low-beam) comes on when operating it through the intelligent tester.
|
OK |
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
|
| NG |
|
 |
|
| 2. INSPECT HEADLIGHT RELAY |
 |
- Remove the HEAD relay from the No. 2 engine room relay block.
Measure the resistance according value(s) in the table below.
- Standard resistance:
Tester connection
|
Condition
|
Specified Condition
|
3 - 5
|
Voltage is not applied between terminals 1 and 2
|
10 kΩ or higher
|
3 - 5
|
Apply the battery voltage between terminals 1 and 2
|
Below 1 Ω
|
Reinstall the HEAD relay.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (BATTERY - HEADLIGHT RELAY) |
 |
Remove the HEAD relay from the No. 2 engine room relay block.
Measure the voltage according value(s) in the table below.
- Standard voltage:
Tester Connection
|
Condition
|
Specified Condition
|
HEAD relay terminal 1 - Body ground
|
Always
|
11 to 14 V
|
Reinstall the HEAD relay.
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 4. CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY - MAIN BODY ECU) |
 |
- Remove the HEAD relay from the No.2 engine room relay block.
Disconnect the 1B main body ECU connector.
Measure the resistance according value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
HEAD relay terminal 2 - 1B-8 (HRLY)
|
Always
|
Below 1 Ω
|
HEAD relay terminal 2 or 1B-8 (HRLY) - Body ground
|
Always
|
10 kΩ or higher
|
Reinstall the HEAD relay.
Reconnect the main body ECU connector.
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|