HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Nov 2010 – Jul 2011
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014
- HINT:
- Use these procedures to troubleshoot the combination meter.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
| 3.CHECK CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result
Result
|
Proceed to
|
CAN communication DTC is not output
|
A
|
CAN communication DTC is output
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 4.REFER TO PROBLEM SYMPTOMS TABLE |
- HINT:
- Refer to the Problem Symptoms Table (Click here).
Result
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 5.CONDUCT ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here)
Data List / Active Test (Click here)
On-vehicle Inspection (Click here)
| NEXT |
|
 |
|
|
| 6.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|
| 7.CONDUCT CONFIRMATION TEST* |
| NEXT |
|
 |
|
|