2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2011 – Jul 2012

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014

HINT:
  1. Use these procedures to troubleshoot the combination meter.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result 
      Result
      Proceed to
      CAN communication DTC is not output
      A
      CAN communication DTC is output
      B


    B.
    A

    4.REFER TO PROBLEM SYMPTOMS TABLE

      HINT:
      Refer to the Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B

    B.
    A

    5.CONDUCT ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)

    3. On-vehicle Inspection (Click here)

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      7.CONDUCT CONFIRMATION TEST*
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Nov 2010 – Jul 2011)HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2012 – Oct 2012) →