INSTALLATION
Removal / installation · Vehicles built from Jul 2007
| 1.
INSTALL STOP LIGHT SWITCH |
 |
- Install the stop light switch into the adjuster until it slightly touches the brake pedal.
- NOTICE:
- Do not depress the brake pedal.
- Make a quarter turn clockwise to install the stop light switch.
- NOTICE:
- Do not depress the brake pedal.
- HINT:
- The turning torque for installing the stop light switch is as below.
-
Torque:
- 1.5 N*m{
15 kgf*cm
, 13 in.*lbf
}
or less
Check the stop light switch clearance.
- Stop light switch clearance:
- 0.5 to 2.6 mm (0.020 to 0.102 in.)
- Connect the stop light switch connector to the stop light switch.
| 2.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 3.9 N*m{
40 kgf*cm
, 35 in.*lbf
}