REMOVAL
Removal / installation · Vehicles built Jul 2007 – Jul 2011
Versions by build date: Jul 2007 – Jul 2011 from Aug 2011
| 1.
REMOVE WINDSHIELD WIPER ARM COVER |
 |
- Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 3 front wiper arm cover.
| 2.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH |
 |
- Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
Remove the nut and front wiper arm.
| 3.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (CENTER SIDE) |
 |
- HINT:
- Use the same procedure as for the LH side.
| 4.
REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 5.
REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY
|
 |
Remove the radio antenna pole by turning it in the direction of the arrow shown in the illustration.
| 6.
REMOVE ANTENNA ORNAMENT |
 |
- Pull out the antenna ornament vertically.
| 7.
REMOVE FRONT FENDER SIDE PANEL UPPER RH |
 |
- Disengage the 4 clips and remove the front fender side panel upper RH.
Remove the 4 clips from the front fender side panel upper RH.
| 8.
REMOVE FRONT FENDER SIDE PANEL UPPER LH |
 |
- Disengage the 4 clips and remove the front fender side panel upper LH.
Remove the 4 clips from the front fender side panel upper LH.
| 9.
REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY |
 |
- Disengage the 7 clips and remove the cowl top ventilator louver sub-assembly.
| 10.
REMOVE COWL TOP VENTILATOR LOUVER RH |
 |
- Disengage the clip and remove the hood to cowl top seal.
Remove the 3 clips and the claw, and remove the cowl top ventilator louver RH.
| 11.
REMOVE COWL TOP VENTILATOR LOUVER LH |
 |
- Remove the 5 clips.
Disengage the 7 claws and remove the cowl top ventilator louver LH.
| 12.
REMOVE FRONT WIPER MOTOR AND LINK |
 |
- Remove the 5 bolts.
Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.
| 13.
REMOVE FRONT WIPER MOTOR |
 |
- Using a screwdriver with its tip wrapped in protective tape, disengage the meshing of the rod at the crank arm pivot of the front wiper motor.
- Using a screwdriver with its tip wrapped in protective tape, disengage the meshing of the rod at the crank arm pivot of the front wiper motor.
- Using "Torx" socket wrench T30, remove the 2 bolts and the front wiper motor.