2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Aug 2011

Versions by build date: Jul 2007 – Jul 2011 from Aug 2011


1. REMOVE WINDSHIELD WIPER ARM COVER

  1. E127858E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 3 front wiper arm cover.


2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

  1. E127859
    Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

  1. Remove the nut and front wiper arm.


3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (CENTER SIDE)

HINT:
Use the same procedure as for the LH side.


4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


5. REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY

  1. E148352
    Using a 8 mm (5/16 inch) wrench, remove the radio antenna pole sub-assembly by turning it counterclockwise.


6. REMOVE ANTENNA ORNAMENT

  1. E127861E01
    Pull out the antenna ornament vertically.


7. REMOVE FRONT FENDER SIDE PANEL UPPER RH

  1. B210064
    Disengage the 4 clips and remove the front fender side panel upper RH.

  1. Remove the 4 clips from the front fender side panel upper RH.


8. REMOVE FRONT FENDER SIDE PANEL UPPER LH

  1. B210065
    Disengage the 4 clips and remove the front fender side panel upper LH.

  1. Remove the 4 clips from the front fender side panel upper LH.


9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

  1. E127863
    Disengage the 7 clips and remove the cowl top ventilator louver sub-assembly.


10. REMOVE COWL TOP VENTILATOR LOUVER RH

  1. E127864
    Disengage the clip and remove the hood to cowl top seal.

  1. Remove the 3 clips and the claw, and remove the cowl top ventilator louver RH.


11. REMOVE COWL TOP VENTILATOR LOUVER LH

  1. E127865
    Remove the 5 clips.

  1. Disengage the 7 claws and remove the cowl top ventilator louver LH.


12. REMOVE FRONT WIPER MOTOR AND LINK

  1. E127866
    Remove the 5 bolts.

  1. Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.


13. REMOVE FRONT WIPER MOTOR

  1. E127867E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the meshing of the rod at the crank arm pivot of the front wiper motor.

  1. E127868E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the meshing of the rod at the crank arm pivot of the front wiper motor.

  1. E127869
    Using "Torx" socket wrench T30, remove the 2 bolts and the front wiper motor.

← REMOVAL (Jul 2007 – Jul 2011)INSPECTION (Jul 2007 – Oct 2010) →